Mạch Đóng Ngắt Relay NB 12V

1 Way 12V Relay Module with Shell Adjustable Trigger Delay Cycle Timing Pull on Switch Multifunction timer

1, the relay trigger pull signal, the time is up, the relay off, during the delay
A again invalid activation B: activation again to restart the timer C: reset the reset relay again
2, the trigger signal start time T1, the time to the pulling drag time T2 off (reset)
T1 and T2 can be adjusted
3, recycling: connect to T1, disconnect T2, infinite loop. T1 and T2 can be adjusted
4, there is a signal, the pull in drag, keep contact, the signal disappears, the start time, the time is up, the relay is off, during the delay, again to Signals, delays canceled, signals disappear, re-timers.
Pulling drag, usually start and end popular of the switch, usually closed and popular end off;
Operation mode: after the power is on, press K1 for 2 seconds after entering the selection mode, P1-1 ~ P1-4 can be selected, P1-1 mode: relay activation signal, Booth relay off. Here, the user can set the time relay T, click the K2 hundredth digit pipe start flashing in K3 press, 100 digital change; Click the K2 ten digital tube start flashing, then hit K3, ten digit digital shift; Click on K2 digital tube start flashing, then hit K3, a digital change; Then hit K2, digital tube; No longer flashing, then hit the decimal point K3 decimal point shift, said in a 0 to 999 minutes in the ten bits 0-99.9 seconds without decimal points 0-999 seconds; After to choose, this time set. Fine adjustment can enter the function set, the default trigger time delay is invalid, click K1, for a delay time to shoot (re time), click K1, For a delay time (reset timer off, reset relay, click on Default) repeat the first set.
P1-2 mode of operation: signal start time X time to the pulling drag off Y. the user can set the time of the pull drag X, Y; The setup time is similar to that of the P1-1 which is different from the blue light indicating the setting of the pulling torque in time, the green light that sets the relay off time. Press K1 short, can enter the function of adjust fine settings, the default delay time is invalid, click on K1, the delay time to activate an effective (re-timer), and after Click on the default settings for the first time.
P1-3 mode: X seconds, disconnect Y seconds, loop infinite. The user can set the pull time relay X, Y; Set the same time as P1-2. Press K1 short, can enter the functions of fine adjustment settings, first turn on X, disconnect Y seconds, click on K1, first disconnect X, connect Y seconds, and then click on the set Set defaults for the first time.
P1-4 mode: trigger the relay signal but not the start time, the trigger signal disappears T start time, at that time, the relay is turned off; In the process of delay time, again to cancel the delay signal command, keep the signal drag disappear, the start time; (The equivalent of press release start time, usually used in power delay). The user can set the time of the drag pull T; Set the same time as P1-1.